Loading...
41
During the installation, the User Account Control pop-up window may appear several times. Accept this
pop-up and allow it to automatically install the software and drivers. When the software has finished
installing WSM Client Configuration Wizard will appear.
Figure 53: WSN Client Config Wizard
Use the following guidelines to complete the WSM Client Config Wizard:
Enter the Authentication Server Info IP Address to be used by the WSM OS Authentication
Service (this address is the same as the Core Server). The Port information is automatically filled in
with the default value. If the system administrator has changed the port number during the WSM
server install, then make sure the Port has the same value.
The Imaging Server Info IP Address is a read-only field and is the same as the Authentication
Server IP Address. It is used by the WSM OS Streaming Service. The Port information is
automatically filled in with the default value. If the system administrator has changed the port number
during the WSM server install, then make user the Port has the same value.
Enter the Web Server Info Port address, if necessary. This is the port on which the Web server runs.
The Port information is automatically filled in with the default value. If the system administrator has
changed the port number during the WSM server install, make sure the Port has the same value.
Do not change the IOS Max Packet Length. This field was used when either the WSM Client or
Server is a version earlier than WSM 3.6.1 (with WSM 3.6.1 or later, the client auto-discovers MTU
on boot up).
The Client Info IP Address, Port, Subnet Mask, and Gateway IP Address are automatically set
and should not be changed.
Click Ok and then Finish completing the installation.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com