Loading...
a. Ethernet Speed — Normally the default (Auto-Detect) should be selected, but another selection
can be made if automatic negotiation is not supported by your network equipment. Selections
include Auto-Detect, 10 MB Half-Duplex, 10 MB Full-Duplex, 100 MB Half-Duplex, 100 MB Full-
Duplex, and 1 GB Full-Duplex.
The 10 MB Full-Duplex option can be selected locally at the device, however, this mode may
need to be negotiated through AutoDetect.
b. The IPV4 check box is selected by default. Click Properties to set various options supported by
IPV4.
Dynamically allocated over DHCP/BOOTP — Selecting this option enables your thin client to
automatically receive information from the DHCP server. The network administrator must
configure the DHCP server using DHCP options to provide information. Any value provided by
the DHCP server replaces any value entered locally on the Options tab, however, locally
entered values are used if the DHCP server fails to provide replacement values.
Statically specified IP Address — Select this option to manual enter the IP Address, Subnet
Mask and Default Gateway:
IP Address — Must be a valid network address in the server environment. The network
administrator must provide this information.
Subnet Mask — Enter the value of the subnet mask. A subnet mask is used to gain access
to machines on other subnets. The subnet mask is used to differentiate the location of
other IP addresses with two choices: same subnet or other subnet. If the location is other
34
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com