VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
Chapter 3: Basic Installation
Factory Default Settings
Before configuring your, you need to know the following default settings.
Web Interface (Username and Password)
The default username and password are “admin” and “admin” respectively.
Device LAN IP settings
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
LAN Port WAN Port
IP address 192.168.1.254
Subnet Mask 255.255.255.0
DHCP server function Enabled
IP addresses for
distribution to PCs
100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP.
If you ever forget the username/password to login to the router, you may
press the RESET button up to 6 seconds to restore the factory default
Caution: After pressing the RESET button for more than 6 seconds, to be sure you powe
cycle the device again.