Loading...
6 Cam Brake Assembly and Installation
26 ArvinMeritor Maintenance Manual MM-0361 (Revised 04-10)
Figure 6.17
14. Install slack adjuster shims at the adjuster end of the camshaft.
Figure 6.18.
Figure 6.18
15. Install the slack adjuster retaining ring at the adjuster end of
the camshaft. Figure 6.19.
Figure 6.19
16. If disassembled, install the nut and push rod yoke onto the air
chamber push rod.
17. Install the pin and retainer that engages the push rod yoke and
the slack adjuster plunger rod. Figure 6.20.
Figure 6.20
18. The distance from the back of the brake air chamber to the
center of the clevis pin is the brake slack adjuster position
(BSAP). Adjust the slack adjuster position to obtain the correct
specification in Table B.
Table B
19. Tighten the nut on the push rod to the clevis pin to the correct
torque. Refer to Section 8.
20. Install the dust shields to the brake spider. Tighten the
mounting screws to the correct torque. Refer to Section 8.
Figure 6.21.
Figure 6.17
Figure 6.18
Figure 6.19
4000789a
4000790a
4000791a
Figure 6.20
Slack Adjuster Length BSAP
5.5" (139.7 mm) 6.3" (160.02 mm)
6.0" (152.4 mm) 6.43" (163.32 mm)
4000792a
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com