Loading...
42 Optional Equipment
© Travis Industries 93508061 4150520
Stove Leg Installation (Brass # 99200500, Cast Black # 99200800, Sculptured # 99200105)
Raise the stove 8" (use lumber). Attach each leg following the instructions below.
Pedestal (Part # 99200200)
If using outside air with the pedestal, follow the directions on the following page under "Outside Air
Installation" prior to installing the pedestal.
Mobile Home installations require the pedestal to be attached to the floor (use the lag bolts).
Place the pedestal into position on the floor protection. Lift the pedestal up and insert the two dowels
included with this kit onto the forward and rear edge of the pedestal base.
Lift the stove onto the pedestal base. Line up the press-nuts on the bottom of the stove with the two
attachment brackets on the pedestal. Insert the two bolts, with washers, through the brackets on the
pedestal and into the stove. Tighten the bolts with a 9/16" wrench.
Attach each leg to the stove by
inserting a bolt and washer through the
hole or slot in the leg and into the
threaded hole on the stove.
9/16" Socket Wrench
These rubber-tipped bolts are for leveling the stove.
Make sure they contact the floor. Do not adjust
with weight on the legs, the rubber tips may tear.
The dowels insert onto
the front and back edge
of the pedestal base.
T
he two pedestal bolts
a
ttach the pedestal to
t
he bottom of the stove.
Pedestal
9/16" Wrench
The lag bolts and washers may be
inserted through these holes to
anchor the pedestal to the floor.
Stove
Early models mount to the
pedestal through these holes.
If using outside air, tuck
the insulation under the
sides of the pedestal.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com