Using The Scan Tool
3 – 20 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
3
P1575
Warning Buzzer
Malfunction
To enter another DTC, press
BACK.
Press BACK again to return to the Main Menu or Diagnostic
Menu.
Connecting The Scan Tool
To diagnose a vehicle, connect the DLC cable to the vehicle’s DLC.
Refer to “Data Link Connector (DLC)” in section2, Getting Started.
If you just want to power up the tool to do self-tests, code lookup, review
or printing data from the last vehicle tested, then you do not need to
attach the cable to the DLC. The internal battery provides power for this.
For more information on OBD II connectors, go to
http://www.obdclearinghouse.com/oemdb.
Vehicle Selection
AutoID™ uses the VIN to determine the type of vehicle the tool is
connected to. Vehicle manufactures began programming the VIN into
the vehicle controller in 2000, but it was not an OBD II mandate until
2005. Vehicles between 2000 and 2004 may or may not support
AutoID™, but vehicles after 2005 should support AutoID™. If the tool
is on a vehicle newer than database coverage, the tool will AutoID™ as
MY OBD II / EOBD, or 2012 OBD II / EOBD.
From Main Menu:
1.Select Vehicle Diagnostics.
•Use
UP
or
DOWN
arrow
key until Vehicle Diagnostics
is highlighted.
=====================
Vehicle Diagnostics
Component Locator
Acronyms
Review Data
Main Menu
Print Data
Code Lookup
Vehicle Diagnostics
•Press ENTER.
2006-2019 Rsmanuals.com