CARING FOR YOUR EQUIPMENT
THE INSTALLATION OF THIS APPLIANCE MUST CONFORM WITH LOCAL
CODES OR, IN THE ABSENCE OF LOCAL CODES:
• In Canada: must conform to CSA-B149.2 Propane
Installation code or CSA B149.1 Natural Gas Installation
• In the U.S.A.: must conform to National Fuel Gas Code
ANSI Z223.1./NFPA 54
• Natural Gas and Propane Installation Code CSA B149.1 or
Propane Storage and Handling and code B149.2. or the
Standard for Recreational Vechiles, ANSI A 119.2/NFPA
119.2 and CSA Z240 RV Series, Recreational Vehicle Code
as applicable as per section 1.22.2(a).1.
• Handling and storage of LP cylinders must conform to LP
Gas Code NFPA/ANSI 58. Grill is not for use in or on
recreational vehicles and/or boats.
• All electrical accessories (such as rotisserie) must be
electrically grounded in accordance with local codes CSA
C22.1 or National Electrical Code, ANSI/NFPA 70. Keep any
electrical cords and/or fuel supply hoses away from any
• This grill is safety certified for use in the United States and
Canada only. Do not modify for use in any other location.
Modification will result in a safety hazard.
• Do not build this model of grill in any built-in or slide in
construction. Ignoring this Warning could cause a fire or an
explosion that can damage property and cause serious bodily
injury or death.
Check with management to learn the requirements and fire codes
for using an LP gas grill in your apartment complex. If allowed, use
outside on the ground floor with clearances as stated in Figure 2
from walls or rails. Do not use on or under balconies.
1 m (36")
MODEL MAY NOT BE
EXACTLY AS SHOWN.
DO NOT USE THIS GAS OUTDOOR APPLIANCE
UNDER ANY OVERHEAD COMBUSTIBLE
WHEN DECIDING WHERE TO PLACE YOUR
APPLIANCE, FOLLOW THESE MINIMUM
CLEARANCE DISTANCES TO ADJACENT
• 1 m (36 inches)
from side of unit
(See Figure 2)
• 1 m (36 inches)
from back of unit
(See Figure 2)
• If any accessory installed on this barbeque requires an
external electrical power source, it must be electrically
grounded in accordance with local laws or in the absence
of local laws, with the Canadian Electrical Code CSA
C22.1 or in the U.S., with the National Electrical Code
• The three-prong plug provides protection against shock
hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
• To ensure continued protection against risk of electric
shock, connect to properly earthed outlets only.
• Ensure all electrical supply cords and fuel supply hoses
are kept well away from any heated surfaces.
PROVIDING POWER TO YOUR BARBEQUE
To provide power to the barbecue, plug grounded electrical cord into
rear electrical box as shown. (Page 18, Fig.15)
Plug electrical cord into properly grounded
GFI (Ground Fault Interrupt) receptacle. If
use of an extension cord is required, be
sure that it is a minimum 16 AWG, 3 wire
well insulated cord, marked for OUTDOOR
USE ONLY and properly grounded. (Fig.14)
CAUTION: To ensure continued protection against risk of
electric shock, connect to properly earthed outlets only.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS OUTDOOR COOKING GAS APPLIANCE IS
EQUIPPED WITH A THREE-PRONG
(GROUNDING) PLUG FOR YOUR PROTECTION
AGAINST SHOCK HAZARD AND SHOULD BE
PLUGGED DIRECTLY INTO A PROPERLY
GROUNDED THREE-PRONG RECEPTACLE. DO
NOT CUT OR REMOVE THE GROUNDING
PRONG FROM THIS PLUG.