Loading...
19
Continued Torch & Wire Feed Set Up for Aluminum Wire
(10) Loosen o the inlet guide tube retaining screw
(11) Remove the inlet guide tube from the front end machine euro connector using long nose pliers.
(12) Carefully feed the extended Polymide liner section into the inlet guide tube hole of the machine euro
connector
(13) Feed the extended Polymide liner all the way up and over the drive roller
(14) Tighten the torch euro connection to the machine euro connector
(15) Cut the extended liner with a sharp Stanley knife just in front of the drive roller
(16) Fit an Aluminum contact tip of the correct size to match the diameter of the wire being used
(17) Fit the remaining front end parts to the torch neck ready for welding
(17) Fit the remaining front end parts to the torch
neck ready for welding.
(11 Remove the inlet guide tube using long nose
pliers.
(12) Carefully feed the Polymide liner into
the inlet guide tube hole of the torch euro
receptacle
(14 Tighten and secure the torch euro
connector to the machine euro receptacle
(15) Cut the extended Polymide liner with a
sharp Stanley knife just in front of the drive
roller
(10) Loosen the inlet guide tube retaining
screw.
(16) Fit an Aluminium contact tip of the cor-
rect size to match the wire diameter being
used
(13)Take the extended Polymide liner all the
way up and over the drive roller
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com