Loading...
52 Maintenance
Indicators
There are three indicators which show the status of the projector. Check the following information
about the indicator lights. If there is anything wrong, turn the projector off and contact your dealer.
15. Connect the power and restart the projector.
16. After the startup logo is displayed, reset the lamp timer via the OSD menu.
• Under the Advanced OSD menu, go to System Setup : Advanced > Lamp Settings > Reset
Lamp Timer, and select Reset.
• Under the Basic OSD menu, if there’s no signal connected to the projector, go to Reset Lamp
Timer and select Reset; if there are signals connected, go to Settings > Reset Lamp Timer,
and select Reset.
Do not reset if the lamp is not new or replaced as this could cause damage.
A "Reset Successfully" message is displayed to notify that the lamp time has been reset to "0".
Light Status & Description
Power events
Orange Off Off Stand-by mode
Green
Flashing Off Off Powering up
Green Off Off Normal operation
Orange
Flashing Off Off Normal power-down cooling
Red Red Red Downloading
Green Off Red CW start fail
Red Off Red Scaler reset fail
Green Off Off Burn-in ON
Green Green Green Burn-in OFF
Lamp events
Off Off Red Lamp1 error in normal operation
Off Off Orange
Flashing Lamp is not lit up
Thermal events
Red Red Off Fan 1 error (the actual fan speed is ±25% outside the desired
speed)
Red Red
Flashing Off Fan 2 error (the actual fan speed is ±25% outside the desired
speed)
Red Green Off Fan 3 error (the actual fan speed is ±25% outside the desired
speed)
Red Green
Flashing Off Fan 4 error (the actual fan speed is ±25% outside the desired
speed)
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com