Loading...
Maintenance64
Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace
the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may explode.
Go to http://lamp.benq.com for a replacement lamp.
The LAMP indicator light and TEMPerature warning light will light up if the lamp becomes too
hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator
still lights up after turning the power back on, please contact your dealer. See "Indicators" on
page 68 for details.
The following Lamp warning displays will remind you to change the lamp.
"XXXX" shown in the above messages are numbers that vary depending on different models.
Status Message
Install a new lamp for optimal performance. If the
projector is normally run with Economic selected
(See "Getting to know the lamp hour" on page 63),
you may continue to operate the projector until
the next hour lamp warning appears.
Press ENTER to dismiss the message.
It is strongly recommended that you replace the
lamp at this age. The lamp is a consumable item.
The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp
whenever you notice that the brightness level has
significantly diminished.
Press ENTER to dismiss the message.
The lamp MUST be replaced before the projector
will operate normally.
Press ENTER to dismiss the message.
OK
Order Replacement Lamp
Lamp>XXXX Hours
Order a new lamp at lamp.benq.com
Notice
OK
Order Replacement Lamp
Lamp>XXXX Hours
Order a new lamp at lamp.benq.com
Notice
OK
Out of Lamp Usage Time
Replace lamp (refer to User Manual)
Then reset lamp timer
Order a new lamp at lamp.benq.com
WARNING
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com