Loading...
18
(5) Select Ignition Current. Push the key until the Ignition
Current icon illuminates. Turn the Adjustment Knob to set the
Ignition Current, the set current will be shown on the Digital Dis-
play. Refer to Page 14 for instruction on Ignition Current.
AC
AC
DC
ALARM
AC PULSE
DC PULSE
DC
Job Recall
Torch Cycle
Volts
ADJUSTMENT
Finish
Current
Start
Current
Peak
Current
Base
Current
Ignition Current
Ignition
Time
Current
Arc Force
Remote
ON/OFF
AC Balance AC Hz % Pulse Pulse Hz
Set Up Procedure for MMA (Stick) Welding:
(1) Connecting the Welding Lead Set: Various electrodes require a different polarity for optimum results
refer to the electrode manufacturers information for the correct polarity. Most GP electrodes are
Electrode connected to output socket, Earth Connected to the output socket
(2) Turn the power source on using the on/off switch located on the front control panel.
(3) Select you preferred MMA mode using the MODE selector key.
(1) Connect Earth Lead
the terminal
(2) Turn on the Power source
using the on/off switch at the
rear of the machine
(1) Connect theElectrode Lead
lead to terminal
MMA - Current Set MMA - Ignition Current Set
MMA (Stick Electrode) Welding Set and Operation
AC
AC
DC
ALARM
AC PULSE
DC PULSE
DC
Job Recall
Torch Cycle
Volts
ADJUSTMENT
Finish
Current
Start
Current
Peak
Current
Base
Current
Ignition Current
Ignition
Time
Current
Arc Force
Remote
ON/OFF
AC Balance AC Hz % Pulse Pulse Hz
(4) Select the Welding Current push the key until the Current
icon is illuminated. Set the weld amperage by rotating the
Adjustment Knob. Set the amperage according to the electrode
type and size as recommended by the electrode manufacturer. The
the set amperage will show in the Digital Display.
(3) Select preferred MMA mode
using the MODE selector key
Razorweld
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com