Loading...
14
Razor2OOAC/DC TIG-ARC
Razorweld
Turn the Encoder to
adjust the Spot time
(Range is 0.5-10 sec)
Spot: Select SPOT using the Torch Mode Selector.
Select Spot time by pushing the encoder to cycle
through to illuminate the Spot icon. The Spot icon
will only activate when in TIG mode and SPOT torch
mode is selected.. Spot will NOT activate whilst the
power source is in remote mode.
The value selected shown on the digital
display represents the time in seconds that
the welding current will be delivered once
the torch switch is pressed.
Spot - Provides selection of a pre-set time period for welding current output.
Allows adjustment of the time that machine will deliver amperage output from trigger activation.
Turn the Encoder to
adjust the Arc Force
Spot: Select ARC using the Weld Mode Selector. Select
ARC FORCE by pushing the encoder to
cycle through the arc force icon illuminate
the Arc Force icon. It will only activate when in ARC mode.
The value selected shown on the digital
display represents extra current over time
applied to the electrode when short circuit is
about to occur. Low value allows a soft arc,
a higher value allows stronger digging arc.
Arc Force - Provides selection for adjustment of the ARC FORCE during ARC (Stick) welding.
Allows setting from a soft buttery arc characteristic through to a more digging, penetrating type of arc.
Continued - Weld Program Selection & Setting
Icon selection: Select by pushing the Encoder Knob repeatedly to cycle
through the weld parameter icons. The icon will illuminate when selected.
4C - Other front panel Icon selection
Turn the encoder to set the
electrode Ø inch value
Tungsten electrode : Select by pushing the
encoder knob to cycle through to illuminate the
Tungsten electrode Ømm icon.
The electrode diameter value
selected will in the digital display.
Tungsten electrode Øinch - for selection of Tungsten electrode and ARC electrode diameter
Remote - indicates remote control activation
The remote icon illuminates when the remote
function is active.
Remote Hand Control. Press the torch switch
and hold for 5 seconds the icon will illuminate
when remote function is activated.
Remote Foot Control. Remote function will be-
come active when the foot control is connected .
Parameter Warning - indicates weld parameters do not match
the electrode Øinch selection
The warning parameter icon illuminates when the
the weld parameter settings do not match the electrode
size selection.
The machine will still function but it is a warning to the
operator that the weld parameters chosen are outside
the generally accepted capabilties of the electrode size
selected. For example excessive amperage selected
may overheat and destroy the tungsten electrode.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com