Loading...
25
EN
Drive Sets the sequential shooting function.
oSingle One frame is shot each time the shutter button is pressed.
jSequential The images are taken sequentially while holding down the shutter for up to 200
frames.
cHigh-Speed1 The camera takes sequential shots at approximately 1.5 frames/sec.
dHigh-Speed2 The camera takes sequential shots at approximately 15 frames/sec.
Image size Sets the number of recording pixels.
4608×3456 Suitable for printing pictures over A3 (11×17 in.).
43200×2400 Suitable for printing pictures up to A3 (11×17 in.).
31920×1440 Suitable for printing pictures up to A4 size (8.5×11 in.).
7640×480 Suitable for using pictures on emails.
Aspect Sets the horizontal-to-vertical ratio of images.
4:3 Change the horizontal-to-vertical ratio to 4:3 when taking pictures.
P16:9 Change the horizontal-to-vertical ratio to 16:9 when taking pictures.
Q3:2 Change the horizontal-to-vertical ratio to 3:2 when taking pictures.
1:1 Change the horizontal-to-vertical ratio to 1:1 when taking pictures.
In certain shooting modes, some functions cannot be set. Refer to “List of settings available in each shooting
mode” (p. 57)
The image sizes are the examples when the aspect ratio is set to [].
Registering one touch white balance Registering one touch white balance
Select [ One Touch 1] or [ One Touch 2], face the camera toward a piece of white paper or other white
object, and press the button.
The camera releases the shutter and the white balance is registered. When the white balance was
previously registered, the registered data is updated.
The registered white balance data will not be cleared by turning off the power.
Perform this procedure under the light where the pictures will be actually taken.
When the camera settings are changed, the white balance must be registered again.
When the white balance cannot be registered, check that the white paper fi lls the screen, and then
perform the procedure again.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com