Loading...
10
(1) Connect the T-150 Plasma Torch to the machine. Insert the torch connection into the torch
connection receptacle at the front of the machine and screw up hand tight.
Caution: Be careful not to bend the pins located inside the torch connector.
(2) Connect the earth lead to the output terminal of the machine and tighten.
(3) Connect the air supply to the air connection located at the rear of the machine.
(4) Connect the air supply to the air connection located at the side of the regulator. Connect the regulator
air hose to the rear of the machine. Turn on the air supply. Set air supply to 5-6 Bar / 150-220 lpm.
(5) Connect the machine to the correct power supply and switch on the machine using the on/off switch
located at the rear of the machine Turn on the air supply.
(6) Set the Amperage dial to the required setting.
Set Up Procedure for PLASMA Cutting
12
(1) Connect the T-150 Plasma Torch to the machine.
Insert the torch connection into the torch connection receptacle at the
front of the machine and screw up hand tight.
Caution: Do not to bend the pins located inside the torch connector.
See Page 11 for central adaptor connection
(4) Connect the air supply to the
air connection located at the side
of the regulator. Connect the
regulator air hose to the rear of the
machine. Turn on the air supply.
Set air supply to
5-6 Bar / 150-220lpm.
(3) Attach the regulator bracket to
back machine and tighten bolts,
then attached regulator to the
bracket
(5) Connect the machine to the
correct power supply and switch
on the machine using the on/off
switch located at the rear of the
machine.
(6) Set the Amperage dial to the
required setting.
(2) Connect the earth lead to the output terminal of the machine
and tighten.
+
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com