Description of each menu
DESCRIPTION (default setting/value)
Corrects the projected picture’s color when the projection surface is
not white. See "Using Wall Color" on page 33 for details.
There are four options to set the image's aspect ratio depending on
your input signal source. See "Selecting the aspect ratio" on page 31 for
Corrects any keystoning of the image. See "Correcting keystone" on
page 30 for details.
Displays the position adjustment page. To move the projected image,
use the directional arrow keys. The values shown on the lower position
of the page change with every key press you made until they reach
their maximum or minimum.
(depends on the
Adjusts the clock phase to reduce image
(0) Adjusts the horizontal width of the image.
Magnifies or reduces the projected image. See "Magnifying and
searching for details" on page 30 for details.
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting a
picture mode" on page 32 for details.
Selects a picture mode that most suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See "Setting the User 1/User 2 mode" on page 33 for
Adjusts the brightness of the image. See "Adjusting Brightness" on
page 33 for details.
Adjusts the degree of difference between dark and light in the image.
See "Adjusting Contrast" on page 33 for details.
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 34 for details.
1. DISPLAY menu 2. PICTURE menu