There are three indicators which show the status of the projector. Check the following information
about the indicator lights. If there is anything wrong, turn the projector off and contact your dealer.
15. Connect the power and restart the projector.
16. After the startup logo is displayed, reset the lamp timer via the O SD menu.
• Under the Advanced O SD menu, go to System Setup : Advanced > Lamp Settings
Lamp Timer, and select Reset.
• Under the Basic O SD menu, if there’s no signal connected to the projector, go to Reset Lamp
Timer and select Reset; if there are signals connected, go to Settings > Reset Lamp Timer,
and select Reset.
Do not reset if the lamp is not new or replaced as this could cause damage.
A "Reset Successfully" message is displayed to notify that the lamp time has been reset to "0".
Light Status & Description
Power event s
Orange Off Off Stand-by mode
Flashing Off O ff Powering up
Green Off Off N ormal operation
Flashing Off O ff N ormal power-down cooling
Flashing D ownloading
Green Off Red CW start fail
Red Off Red Scaler reset fail
Green Off Off Burn-in O N
Green Green Green Burn-in O FF
Off Off Red Lamp1 error in normal operation
Off Off Red
Flashing Lamp is not lit up
Red Red Off Fan 1 error (the actual fan speed is ±25% outside the desired
Flashing Off Fan 2 error (the actual fan speed is ±25% outside the desired
Red Green Off Fan 3 error (the actual fan speed is ±25% outside the desired
Flashing Off Fan 4 error (the actual fan speed is ±25% outside the desired