Loading...
39
Menu Functions
System Setup : Advanced menu
Submenu Functions and Descriptions
Lamp Settings
Reset Lamp Timer
Activate this function only after a new lamp is installed. W hen you select Reset,
a "Reset Successfully" message is displayed to notify that the lamp time has
been reset to "0".
• Lamp Timer
Select to learn the duration (in hours) of lamp usage which is automatically
calculated by the built-in timer.
Total (equivalent) lamp hour = 2.0 x (hours used in N ormal mode) + 1.4 x
(hours used in Economic mode) + 1.0 x (hours used in SmartEco mode)
HDMI Settings
H DMI Range
Selects a suitable RGB color range to correct the color accuracy.
Auto: Automatically selects a suitable color range for the incoming
HD MI signal.
Full: Utilizes the Full range RGB 0-255.
Limited: Utilizes the Limited range RGB 16-235.
HDMI Range is only available when the HDMI signal is selected.
CEC
W hen you connect an HD MI CEC-compatible device to your projector with an
HD MI cable, turning on the HD MI CEC compatible device automatically turns
on the projector, while turning off the projector automatically turns off the
HD MI CEC compatible device. You can use the projector’s remote control to
control your HD MI CEC-compatible devices. See item 17 on page 10 for
details.
Power O n Link/Power O ff Link
W hen you connect an HD MI CEC-compatible device to your projector with an
HD MI cable, you can set the behavior of powering on/off between the device
and the projector.
Baud Rate
Select a baud rate that is identical with your computer’s so that you can connect
the projector with a suitable RS-232 cable and update or download the
projector’s firmware. This function is intended for qualified service personnel.
Te st P a t t e r n Enable this function to display the grid test pattern, which helps you adjust the
image size and focus so as to check if the projected image is free of distortion.
Quick Cooling Select On to shorten the projector cooling time from a normal 90-second
duration to approximately 15 seconds.
Bidirectional Turning on/off either the connected device or the
projector can turn on/off both.
From Projector W hen the projector is turned on/off, the connected
device will be activated/shut down, too.
From Device W hen the connected device is turned on/off, the
projector will be activated/shut down, too.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com