Loading...
23
Continued set up of the Spool Gun for RAZOR 175-200 MIG
(8) Carefully feed the wire through the red guide tube into meet the drive roller. Push down the tension
arm adjustment lever to release the drive roll pressure allowing the wire to be guided through the drive
rollers into the gun neck.
(9) Replace the spool cover
(10) Remove the gas nozzle and contact tip from the torch neck, Pull the trigger to drive the wire through
the neck until it exits the contact tip holder.
(11) Fit the correct sized contact tip by feeding the wire through it, screw the contact tip into the tip holder
of the torch neck and nip it up tightly.
(12) Check the drive roll pressure is enough to drive the wire smoothly and adjust the drive roll pressure if
required by using the adjusting screw at the top of the torch body. Do not apply too much pressure.
(13) Fit the gas nozzle to the torch head.
(14) 
(15) Set the welding parameters using the wire feed and voltage control knobs.
(16) Using the Burn Back 
 
(8) Carefully feed the wire through the inlet
guide tube onto the drive roller through into
the outlet guide tube. Push down the tension
arm lever to release the pressure of the drive
roller allowing the wire to be guided through
the drive roller into the gun neck.
(9) Replace the Spool Cover.
(15) Set welding parameters using the
voltage and wire feed controls.
(16) Adjust the burn back control to prevent
the wire sticking in the weld pool.
Caution:
Disconnect the Electrode Holder cable from the machine before using MIG function. If cable is not disconnected welding

(12) Adjust the drive roll pressure if required
by using the adjusting screw at the top of the
torch.
(13) Fit the gas nozzle ready for welding.(11) Fit the contact tip over the wire and
screw it into the tip holder, nip it up tight.
(10) Remove the gas nozzle and contact tip.
Pull the trigger to drive the wire through the
neck until it exits the contact tip holder
(14) Carefully open the valve of the gas

Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com