Loading...
14
Continued set up for MIG with Gas for RAZOR 175-200 MIG
(9) Align the wire into the groove of the drive roller and close down the top roller making sure the wire is in
the groove of the bottom drive roller, lock the pressure arm into place.
(10) Apply a medium amount of pressure to the drive roller.
(11) Remove the gas nozzle and contact tip from the torch neck,
(12) Press and hold the inch button to feed the wire through to the torch neck, release the inch button when
the wire exits the torch neck.
(13) Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the tip holder of
the torch head and nip it up tightly.
(14) Fit the gas nozzle to the torch head.
(15) 
(16) Set the welding parameters using the wire feed and voltage control knobs.
(17) Using the Burn Back 
 
(12) Press and hold the inch wire button to
feed the wire down the torch cable through
to the torch head.
(11) Remove the gas nozzle and contact tip
from the front end of the mig torch.
(13) Fit the correct size contact tip over
the wire and fasten tightly into the tip
holder.
(14) Fit the gas nozzle to the torch head.
(16) Set welding parameters using the
voltage and wire feed controls.
(17) Adjust the burn back control to prevent
the wire sticking in the weld pool.
(9) Close down the top roller bracket and clip
the pressure arm into place.
NOTE: MIG 165 not geared
(10) Apply a medium amount of
pressure to the drive roller
NOTE: MIG 165 not geared
(15) Carefully open the valve of the gas

Page 15
Instructions Manual for VIPE R 182 (K019E)
23/06/2017
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com