27
Using the projector
English
Correcting picture distortion
Keystoning occurs when the projector is not perpendicular to the screen and is where the projected
picture displays visible as a trapezoid shape like either of the following:
Two parallel sides (left and right, or top and bottom) but is noticeably wider on either side.
No parallel sides.
To correct the picture’s shape, you can perform the following steps.
1. Adjust the projection angle. Move the projector to be in front of the center of the screen with the
center of the lens level with the screen.
2. If the picture is still distorted, or the projector is unable to be positioned as described above, you will
need to manually correct the picture.
Using the remote control or projector
i. Press one of the Arrow/Keystone keys (Left / , Up / ,
Right / , Down / ) to display the 2D Keystone page.
ii. See step iii below for further operation.
Using the OSD menu
i. Press MENU/EXIT and then press / until the Display
menu is highlighted.
ii. Press to highlight 2D Keystone and press ENTER. The
2D Keystone page is displayed.
iii. Press the key whose keystone icon is opposite to the shape of the projected picture. Continue
pressing the same key or press the other keys until you are satisfied with the shape.
The values on the lower portion of the page change while pressing. When the values reach their
maximum or minimum with repeated key presses, the picture’s shape will stop changing. You will
not be able to change the picture further in that direction.
Two parallel sides
No parallel sides
Press
/
Press
/
Press
/
Press
/
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com